"Torque" and "Speed" are usually considered important specs. The one 10 Grasper has been developed with the feature of "Holding Power" which provides the feeling of the Torque when driving a car. The “Holding Power” is to hold the position of servo. If this power is strong, a steering is stable. “Grasper” means “holding firmly”. The name of "Grasper” comes from the feature of grasping the road.
Newly designed top case made of Aluminum!
The aluminum top case support the stable ‘Holding Power’
The case is machined after anodizing, creating a sharp design and beautiful edge line of the case.
By shaving off the inside of the case to extremity, while securing sufficient strength, the case is made lighter than the former aluminum case.The black wire servo leads with cool appearance provides suitable softness for installation, while securing necessary current capacity.
HCS (High speed Communcation System) is the new high speed communication system between the receiver to the servo. The HCS mode shortens communication time of the signal which is compressed. HCS compatible servos is changing mode automatically by signal from receiver. So HCS compatible servos can use with all receivers.
If you want to use servos by HCS, please use with HCS compatible receivers.
Installed preset settings
The following factory MODEL settings are pre-installed.
You can chenge setting by Servo Model Selector
Model1: GRASPER POWER SETTING
Model2 to 5:GRASPER NORMAL SETTING(Slected)
*Model2 has been selected in factory setting.Recommend category:
1/10 EP on road, 1/10 EP Off road, 1/10 GP On road.
- Torque: 10.8Kg-cm Speed: 0.09sec/60deg(@7.4V)
- Torque: 8.0Kg-cm Speed: 0.10sec/60deg(@6.0V)
- Dimensions: 40.5×26×21mm (Low Profile)
- Weight: 51.0g
- Operating voltage: 6.0~7.4V (Lipo,Life,Ni-MH)
- The hard alumite aluminum gear
- Brush-less motor
- Dual bearings
- The hard servo gear shaft
- The aluminum top case
- The aluminum heat sink middle case
- Black cable
- Gold plated connector
- HCS Compatible