(0) Item Hello, Guest

KO Propo RSX3- Response  Servo

KO Propo RSX3- Response Servo

Your Price:$164.99
Retail Price:$206.25
You Save:$41.26(20%)
Out of Stock.
Part Number:KOP30123
The aluminum top case support the stable ‘Holding Power’. The case is machined after anodizing, creating a sharp design and beautiful edge line of the case. By shaving off the inside of the case to extremity, while securing sufficient strength, the case is made lighter than the former aluminum case.The black wire servo leads with cool appearance provides suitable softness for installation, while securing necessary current capacity.

HCS (High speed Communcation System) is the new high speed communication system between the receiver to the servo. The HCS mode shortens communication time of the signal which is compressed. HCS compatible servos is changing mode automatically by signal from receiver. So HCS compatible servos can use with all receivers.  If you want to use servos by HCS, please use with HCS compatible receivers.

Installed preset settings

The following factory MODEL settings are pre-installed. 
You can chenge setting by Servo Model Selector

Model1: Standard setting(All category)
         2:"Cody King"setting(1/8GP - Off road)
         3:2016Japan national-turf(1/10EP Off-road)
         4:Dirt(1/10EP Off-road)
         5:For Technical Circuit(All category)

*Model1 has been selected in factory setting.

Features

Current servos have the appearance of high speed and high power from the response of 2.4GHz and the power from Li-po batteries respectively. This creates a huge demand upon the servo. The RSx is the racing servo with the durability and operability to employ this high-spec demand.

1:Case

The middle case is machined from one piece of aluminum that incorporates the gear pins and motor being held properly in place. The top case rigidity has been improved with the addition of two screws in the middle to prevent flex and keep the gears properly aligned. The upper Hard Case (H.C) is also machined from aluminum. H.C is the distinction of durability for categories that demand high stress.

2:Motor

A servo motor is a very important part of a servo. The specification of a servo is up to the motor being used. We have developed a new motor suitable for the new R/C standard with numerous performance and stress tests.

3:Gear

The gears are made with a special Japanese aluminum. This gear is 45% lighter than brass and has the same hardness as steel. The ‘Light Weight’ design provides a clean response for driving and reduces the burden on the servo motor. The thorough quality control of the manufactured gears ensures the least amount of backlash possible for smooth action. And Power and Pawer HC use Special Stainless Gear. It is very strong and useful for off load category.

#Torque:17.6Kg-cm Speed: 0.06sec/60deg(@7.4V)
#Torque:14.5Kg-cm Speed: 0.07sec/60deg(@6.0V)

#Dimensions: 41x38x20cm(Standard size)
#Weight: 65.5g
#Operating voltage:6.0 to 7.4V(Lipo,Life,Ni-MH)
#The hard alumite aluminum gear
#Core-less motor
#Dual bearings
#The hard servo gear shaft
#The aluminum top case
#The aluminum heat shink middle case
#Gold plated connector
#Black cable
#HCS Compatible

#Recommend category
  1/8 Off road, 1/8 On road, 1/10 EP Off road.  

Related Items